Homemade Vibrator

I am going to work on adding some images for this but for now I am going to try to give some good descriptions.

What you need:

1 greenish banana
1 bullet vibrator- I would recommend one with a cord (this will run you about $11)
1 roll of duct tape
1 new condom- if you want to use a used one that is just nasty!
1 small rubber band- like the kind for a small pig-tail or something, you can get these at Walmart for $1 for 100
1 knife- find this in your kitchen- if you do not have a knife borrow one or visit the dollar store and hook your kitchen up!

Step 1: Cut off the very tip of the banana (less than 1/4 inch down- keeping the rounding at the top just getting rid of the tip. Cut the bottom right where the step widens.

Step 2: Slice the banana skin long ways from top to bottom.

Step 3: peel open the banana carefully as to not break the skin of the banana- if you break it will be ok- that is why we have tape!

Step 4: about 1-1 1/2 inches down the banana scoop out a spot that is the same size as your bullet. Also scrape out a shallow ditch in the banana for the cord to sit in all the way to the bottom of the banana.

Step 5: Place the bullet vibrator in the banana and then starting at the top/tip take all the way down the banana leaving about 1/8 inch at the bottom but no more.

Step 6: Once the banana is fully taped with no rough edges, place it in the condom. Take the hair tie and secure the condom and the vibrator cord at the bottom. Make sure the condom is not full of air and that it is snug on the vibrator.

Step 7: ENJOY!

Remember folks- banana's are a fruit- they will spoil Once you are done using your banana vibrator please take it apart carefully and discard all items except the bullet vibrator. You can always reuse the bullet on other occasions!

Please let us know how you and yours like this DIY homemade sex toy!!! A DIY vibrator for women!